Devices: Most devices with chipsets from MediaTek, MStar, and Spreadtrum
Type of Capture: Physical

Procedure

  1. Install the "International" drivers via the Driver Management tab in MPE+
  2. Connect the MPE+ Velocitor to the PC using the provided USB cable
  3. Connect the male end of the "Main Connector" to the MPE+ Velocitor
  4. Remove the battery from the mobile device
  5. Connect the positive and negative clips on the "Main Connector" to the proper pins on the mobile device
  6. Identify the proper cable for the mobile device, and connect it both to the mobile device and to the female end of the "Main Connector"
  7. On the Main toolbar in MPE+, click "Select Velocitor Device"
  8. In the wizard, either check "Auto Detect Chipset" or select the proper chipset manufacturer, then click "Connect"
  9. Follow the wizard's prompts to hold down the mobile device's Power button at the appropriate times
  10. Once the connection has been established, either check "Auto Detect Boot" or select the proper boot loader, then click "Extract Data"
  11. Follow the wizard's prompts to hold down the mobile device's Power button at the appropriate times
  12. When extraction is complete, choose a location to save the image and then MPE+ will proceed to parse data from the image


Notes:

  • The DC/USB Power switch (red button) should be in the up or "USB" position to draw power from the PC's USB connection. DC power is only necessary when the PC has a very low power output over USB.
  • Reversing the power clips will not adversely affect the device, but will impede proper communication.
  • The connection interface in the Velocitor wizard should always be set to "COM".
  • If you need to stop or restart the extraction, click "Reset" before clicking "Cancel".